一般特性 |
---|
Signal type | Analog input |
供电 |
---|
连接器 | Power Rail or terminals 14+, 15- |
额定电压 | 19 ... 30 V DC |
纹波 | ≤ 10 % |
额定电流 | ≤ 50 mA |
功耗 | ≤ 800 mW |
功耗 | ≤ 1.2 W |
输入 |
---|
连接器 | terminals 1+, 3-; 6+, 5- |
输入信号 | 4 ... 20 mA , limited to approx. 27 mA reverse polarity protected |
线路故障检测 | downscaling ≤ 3 mA ; upscaling ≥ 22 mA |
电压降 | approx. 5 V on terminals 5-, 6+ |
Available voltage | ≥ 15 V at 20 mA terminals 1+, 3- |
输出 |
---|
连接器 | 端子 7-,8+ |
负载 | 0 ... 300 Ω (source mode) |
输出信号 | 4 ... 20 mA or 1 ... 5 V (on 250 Ω, 0.1 % internal shunt) 4 ... 20 mA (sink mode), operating voltage 16 ... 28 V |
纹波 | 20 mV rms |
Error message output |
---|
输出类型 | fault bus signal , open collector transistor |
Transfer characteristics |
---|
偏差 | at 20 °C (68 °F) ≤ ± 20 µA incl. calibration, linearity, hysteresis, loads and supply voltage fluctuations (source mode and sink mode 4 ... 20 mA) ≤ 10 mV incl. calibration, linearity, hysteresis and fluctuations of supply voltage (source mode 1 ... 5 V) |
频率范围 | field side into the control side: bandwidth with 1 mApp signal 0 ... 3 kHz (-3 dB) control side into the field side: bandwidth with 0.5 Vpp signal 0 ... 3 kHz (-3 dB) |
Settling time | ≤ 200 ms |
Rise time/fall time | ≤ 20 ms |
指令符合 |
---|
电磁兼容性 | |
| Directive 2004/108/EC | EN 61326-1:2006 |
Conformity |
---|
电磁兼容性 | NE 21:2006 |
防护等级 | IEC 60529:2001 |
周围环境 |
---|
环境温度 | -20 ... 70 °C (-4 ... 158 °F) |
机械特性 |
---|
防护等级 | IP20 |
重量 | approx. 150 g |
外形尺寸 | 20 x 124 x 115 mm (0.8 x 4.9 x 4.5 in) , housing type B2 |
安装 | on 35 mm DIN mounting rail acc. to EN 60715:2001 |
Data for application in connection with Ex-areas |
---|
EC-类型 鉴定证书 | CESI 10 ATEX 076 , for additional certificates see www.pepperl-fuchs。。com |
| 保护型号、类别、组别 | II (1)GD [Ex ia] IIC, [Ex iaD] [circuit(s) in zone 0/1/2/20/21/22] I (M1) [Ex ia] I |
符合标准 | PF 10 CERT 1750 X , observe statement of conformity |
| Group, category, type of protection, temperature class | II 3G Ex nA II T4 |
指令符合 | |
| 94/9/EC 指令 | EN 60079-0, EN 60079-11, EN 60079-15, EN 60079-26, EN 61241-0, EN 61241-11 |
International approvals |
---|
IECEx approval | IECEx CES 11.0005 |